Cleaning Thinner

Go Back to - Home

NAME OF PRODUCT : THINNER CL
Product Ingredients : Combination of Aliphatic & Aromatic Solvents & Ketonic, Esters [70% aliphatic solvent]

Product Data
Density at 30° C 0.8 +/- 0.02
Appearance Colorless Clear liquid.
Odor Typical Smell of aliphatic solvents Non irritating
% Volatile by Volume 100%
Evaporation Rate 04 min to 07 Min. On filter paper [41]
Physical State Liquid.
pH Neutral.
Distillation Range 50°C [first drop] 10ml-100ml [90°C– 1450 C]
It can be used as a thinner for synthetic Enamel. The main purpose of Thinner CL is cleaning jobs to remove oil & Grease

FIRE & EXPLOSION DATA
1. Flash Point : Above 30° C [32° C to 36° C]
2. Extinguishing Media : Carbon Dioxide/Dry Chemical Powder & Water
3. Special Fire Fighting : Should be adopted. Procedures

HEALTH HAZARD INFORMATION
Skin Contact : No Problem
Skin Absorption : Slight Irritation.
Eye Contact : Slight Irritation.
Ingestion : Non Toxic.
Effects of Overexposure : No Problem.

EMERGENCY & FIRST AID PROCEDURES.
Eyes : Wash with Water.

REACTIVITY DATA
Storage: - Store in a clean, cool area protected from sunlight; Containers should be airtight & kept In a moisture free atmosphere, while removing the thinner take care that moisture from Air will not go inside the barrel.

Incompatibility : With water & In Isopropanol or lower alcohols.
Spill or Leak Procedures : Wipe out the spillage with cotton- Waste & Burn the same in safe area.
Neutralizing Chemicals : Clean with soap water.
Waste disposal method : It doesn’t produce any disposable waste.
Ventilation Requirements : Excellent ventilation is required. Use efficient exhaust system.

Specific Personal Protective equipment's
Use air or protective mask
Eye : If necessary use safety goggles.
Gloves : If necessary use PVC gloves.

SPECIAL PRECAUTIONS
Use non-sparking tool. There should not be any welding or firing instrument near the area, where the thinner being used or at the storage system. Prohibit using polyester clothes when handling the thinner as well as in the storage room. Do not smoke or lit fire while working & prohibit the complete area for the same where cleaning & painting is going on.

Disclaimer - The information contained herein is believed to be accurate and is offered in good faith for the guidance of the consumer. We cannot accept any responsibility for errors / mishaps since conditions under which our products may be used are beyond our control. Our Technical Support is always with you.


Reach us

Contact Details

Tuff Coat Polymers Pvt. Ltd.

S. No. 39, 1133, Manikbaug, Vadgaon (Bk.), Sinhagad Road, Pune - 411 051, Maharashtra, India.

Tel No.: +91 - 20 - 24351394 / 24353137

Cell No.: +91 98227 62122